Works awesome! - MDT M-LOK Exterior Forend Weight Set

I am going to mention the one major drawback. The Mlok screws are way to small for thick wall MDT Tac-21 chassis go figure.
I had already bought all kinds of gun type bolts and mlok nuts ahead just incase. So it was not a big problem for me. I would get some bolts if you order this. Nice to have if you lose one anyway.

On to the plus. I had put a carbon fiber barrel on my rifle, inreasing accuracy but greatly decreasing front end weight. To keep dead on with bipod extended really took putting some front pressure on. I put 2 sets of these on and out of 1st 3 rounds 2 landed dead center 1/2 bullseye at 100 yards. The rest were close but off from my own shooting error most likely. The grouping was round on top of round with about 1/8th inch variation. Sucked up lot of the felt recoil as well. A must for an m-lok precision rifle.