Pachmayr Pre-Fit Decelerator Recoil Pads
Currently Unavailable
View Product
Compare (0)
1 item has been added
Add at least two items to compare
Legacy Reviewer's Review of Pachmayr Pre-Fit Decelerator Recoil Pads
I purchased this for a Rem. 700 BDL. The holes do not match for installment. Factory holes are close, but must be plugged. Because they are near the new holes, screws tend to drift during installation. Fit is poor (too Large)requires extensive preparation and sanding. For a product to specifically be recommended for a rifle, this product appears to be a generic pad for all rifles butts. It is the responsibility of the buyer to figure out out to modify it for your rifle.
Pros: Good pad
Cons: Must be modifyied and the hole do not match for the specific rifle
Pros: Good pad
Cons: Must be modifyied and the hole do not match for the specific rifle
This review was written in the old system and had content requirements that are different than reviews written today.
Would Recommend:
No
2 of 3
found the following review helpful.