Good grip glove, but not so much with crimson trace laserguide - Pachmayr Tactical Gun Grip Glove

Good product, with a couple of cautions.

This does not well with the Crimson Trace LaserGuard (LG-469) for the XDS, because it covers over the laser actuating button. The laser still works, for the most part, but sometime it will stay on after releasing the button because of the extra pressure from the grip glove. I tried cutting a hole in the glove (with a hole punch) where the laser actuating button is located, however the stretching tension elongates the hole laterally (sideways). Also, it was a little harder pressing the button with the hole cut in the glove, because the button would be slightly recessed within the hole. It worked OK, but combined with the next item, I ended up taking the glove off.

It is very easy for the glove to slide down over the magazine well, possibly causing a problem seating the magazine, which happened to me, and took a moment to figure out why the magazine would not click into place. If you compensate by pushing the glove higher up on the grip, you have to be careful of the glove contacting the grip safety. All in all, it may require a bit of trimming with a pair of scissors, at least on the bottom, to prevent the glove from creeping over the edge of the magazine well.
Pros: Good fit, easy to install, comfortable
Cons: On the XDS you have to be very carful that it not too close to the magazine, or too close to the grip safety. Trimming may be required.

This review was written in the old system and had content requirements that are different than reviews written today.