I decided on this case so that I could have a rugged lockable case for the range or traveling with multiple firearms. With careful planning, and not getting too far ahead of myself, I was able to fit 3 rifles, 3 pistols and at least 3 mags for each. Experiment with differnt layouts and with rifle assembled and broken down to fit more in. The pluck and pull foam is great to get close to a custom fit insert. When you are certain about the lay out and have fit everything you want, I recommend using a hot glue gun to seal up the pre cut lines in the remaining foam or it will continue to separate. For an extra layer of protection and to keep the foam from falling apart, I used a few cans of plastidip (lowes/HD) to reinforce. Apply in light coats and wait for it to dry before applying another layer. Also, don't spray on too thick or it will slightly "shrink" the foam.
Learn from my mistakes:
1. When you take out all of the layers, stack them in the original order and orientation and mark them with chalk so you can put them back the way they came out. If not, the plucked layers may not line up perfectly. Not a big deal but a little annoyed that I didn't notice this before I started. Now one layer may stick out 1/8"
2. Really be creative about how you orrientate rifles,magazines, gear. To fit in more, I ended up leaving one magazine in each rifle because there was enough space below the lower that wasn't being used.
3. Use a box cutter to cut out 1/2 sections of foam anywh...
Read More...