Finally! i can cast a lot longer with the pro melt! - RCBS Pro-Melt Furnace 120 V-ac - 81100

So far, I have found several points of interest in the RCBS Pro-Melt Furnace that were lacking in other products I have used.

First, No constant dripping. Making start-up a lot less nerve racking.

Secondly, a much higher degree of temp control over the session. The temp just doesn't swing as wildly as the level drops as other brands I have tried.

Thirdly, the actuation lever is "SO much easier to use. Very little movement required, with no drips when I stop a pour. And the volume stays at a more constant rate in relation to the level in the pot. Sure it will eventually change slightly but only after using a large portion of the lead in the pot!

But for me, the biggest advantage is being able to use most of the lead before having to refill the pot. Most offerings suggest that you never take a their pot below 1/2 full before replenishing the pot. The RCBS only requires one to one and one half Inches of depth for safe use without burning up the heating element. This is a huge advantage when casting a lot of bullets!

Happy? Yep, I should say so!

KnifeMaker

But the biggest advantage