Your Browser is Outdated
Real Avid Master Sight Pusher Tool
List:
$192.50
$164.99
Save 14%
Compare (0)
1 item has been added
Add at least two items to compare
Ed G's Review of Real Avid Master Sight Pusher Tool
Advice:
You have to be very careful when using this device. Follow the instructions carefully. I used a flash-lighted head band and continually checked to ensure it wasn't too low nor too high. If it's too low you can scratch the slide, if it's too high you won't get enough torque on the sight. When using the dovetail 5/32 side of the universal press block, you have to ensure the slide is positioned so that the press block isn't touching neither the rear nor front of the dovetail because you could end up widening your dovetail gap.
When loosening the vertical stabilizer, ensure the sides of the mover are clear from the sight or it'll be too tight for you to loosen it.
All this all, this sight mover is affordable and a necessity, if you have bad eyes as I do, and if you are continually changing sights on your firearms frequently.
You have to be very careful when using this device. Follow the instructions carefully. I used a flash-lighted head band and continually checked to ensure it wasn't too low nor too high. If it's too low you can scratch the slide, if it's too high you won't get enough torque on the sight. When using the dovetail 5/32 side of the universal press block, you have to ensure the slide is positioned so that the press block isn't touching neither the rear nor front of the dovetail because you could end up widening your dovetail gap.
When loosening the vertical stabilizer, ensure the sides of the mover are clear from the sight or it'll be too tight for you to loosen it.
All this all, this sight mover is affordable and a necessity, if you have bad eyes as I do, and if you are continually changing sights on your firearms frequently.
Pros:
- I was able to use this on my Glock 34 gen 5 rear sight and on my Beretta 92 front sight. As some of you may know, the front side of 92 Berettas are indented from both sides. This isn't an issue with this device. I was able to clamp it down without issu
Cons:
- Just as with all sight pushers, it can slightly mar your sight (very slight). But that's typical with sight pushers, I've even had gunsmiths install sights and have seen slight marring on them as well. A touch of bluing really helps.
Would Recommend:
Yes
12 of 12
found the following review helpful.