Tighten screws before use - OpticsPlanet Exclusive RISE Armament RA-240 Enhanced Rifle Trigger

When I first installed this trigger it would constantly light strike and occasionally fire on release. After some research on these triggers I found that there are two screws you need to tighten down to keep this from happening. After it’s installed in the lower if you look down from the top you’ll see two grooves going down into the base of the trigger. There is an 5/64 allen head screw there that you need to tighten down. You’ll have to push the hammer springs to the side to access the screws. Once I did that I’ve had no issues and is a major upgrade over a stock mil spec trigger.