Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
Exactly right
Just what I needed to replace a bent one. Now everything works precisely and perfectly (G19 Gen 3). Other ordered items took forever, but this was shipped separately and received quickly. That’s all I have to say..
Would recommend: Yes
Waste of 3 dollars
So imagine building your very first glock and not only does your gun not fully cycle with an 11lb recoil spring because you chose to run a compensator, but every shot causes your mag to drop. Very frustrating to say the least. Pulled the mag release spring and noticed it was slightly bent gun only has 50 rounds through it so far. Just sad. For a little piece of wire you'd think they could get it right.
Pros:
- None
Cons:
- Does not work
- mag drops everytime you fire the gun
Best Used for:
- Garbage
Would recommend: No
Simple Piece..
Quite the price for a clipping of wire. Edges were sharp/burred from cutting. Minimal effort.
A few strokes against sandpaper smoothed the ends out. Did not care for this companies magazine release either.
A few strokes against sandpaper smoothed the ends out. Did not care for this companies magazine release either.
Pros:
- correct length
Cons:
- Expensive
- sharp
Best Used for:
- Budget
Would recommend: No
Good product
Works well and as intended. Installs easy and has good tension on the mag release. use an angled pick to get the rod seated in the mag release button. I installed this on a p80 g17 build and so far so good.
Would recommend: Yes
Mag catch spring
It works exactly how you expect it to. I dont expect to have any problems with this product. Affordable and gets the job done. I would definitely recommend this to anyone who is looking for a mag catch spring.
Would recommend: Yes
There are no reviews that match your criteria. Would you like to review this product?