Reviews & Ratings for Sniper 2 Piece Drop In Quad Rail Handguards — 15 reviews — Page 1

Did not fit my ruger 8500 ar-556 after I was told it would, not problem

The top is too long and the half moon slides don’t lineup the way they are supposed to

Put this on my SW MP15 Sport2, easy install, no tools required,feels great,looks great for the price

Bought this quad rail to replace the MOE handguard on my PSA Marauder and it fits like a glove! Just a quick little pop on and screw in and I can now mount a front iron sight on my Marauder. Definitely a great buy, the Aluminum feels dense and high quality and the fit on the front cap and delta ring has no wiggle at all.

I didn’t have the highest expectations to begin with and I sure wasn’t let down, too hard that is. The rail T markings are light to dark and not uniform any mine came blended on the top of the rail. One of those not so good blems that hides itself but one that’s obvious right where the receiver rail meets the hand guard rail. It’s not bad for a throw around rifle but it’s pretty displeasing on a brand new build. I’ll be replacing it with something similar

Took a while to receive it the turtle got lost I think but finally got it and installed it immediately and added my stuff on my rifle extremely happy would highly recommend optics planet to everyone looking forward to getting more stuff

Bought this with high hopes, initially thought it would work, then I thought it wouldn't, then I went on to YouTube and looked up the UTG Leapers version of this quad rail (this one is essentially a copy of that, anyway, if it doesn't fit, it's because the rail extension that goes over the Delta ring might be a millimeter too long, no big deal, here's what you do. Get some hundred sandpaper, a flat surface like your kitchen countertop, or a really flat workbench, hold the quad rail top steady and perfectly vertical, sand down that rail extension paying attention and being very careful to keep it even and level, true to the sanding surface, you want to make that sanding line as straight as the factory cut, take off a little bit at a time, keep refitting it, and then all of a sudden it'll fit perfectly and you will be ready to go. The people on here that don't think it will fit need to get used to gunsmith things, sometimes with a gun you need your armorers tool or some files or some sandpaper, you don't want to be sanding on the gun, but sanding on an accessory like this at its cost is no big deal, it saved me a ton of money and it took me about 10 minutes of sanding. Totally worth it. Looks awesome I'll try to post a picture

Does not fit the smith and wesson mp sport 2 optic ready. This handguard is 1/16 too long to fit it correctly. Busted up my hand and my friends and to pull delta ring and no matter what it will not fit. If you insert delta ring side, the little extended picatinny(on handguard) will not allow it any farther by touching with the upper receiver picatinny. If you insert handguard towards muzzle end first, the delta ring section will seat crooked and not click in right. I do not want to waste my time chipping away the handguard by 1/16 so I will just buy a new handguard.

This handguard may work for your mp15 sport 2, but certainly not mine.
Dear, our busted up hands.

I had to modify the area for the gas tube that at the Delta ring. Not enough material removed for a smooth fit. May be the entry level AR. The alignment humps on either side of the quad rail had to be removed with a dremel.the area for the gas tube also had to be dredged out so the tube would fit . I still loke the cost and it was an easy fix with a dremel.

I just received the guard and was very impressed with how sturdy it was. I like the fact that the top rail does come all the way to the rail on my upper. It’s very sturdy and I can now use my bipod with stability. It just looks like it should have cost much more. I highly recommend this product.