Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
AP's Review of Spikes Tactical ST Micro Rifle Gas Block
I got this specifically because of the approximately .420 screw hold spacing for a Daniel Defense 10.3 barrel. The DD barrels come pre-dimpled from the factory, and this one does match up almost exactly based on my calipers.
It appears to have a nitride finish, and the inside in machined well. Mine did not include a gas tube roll pin, so that's a drawback. The set screws are also flat face, they are not knurled. However, if you're planning to pin it, that won't be a problem
It is absolutely small enough to fit within a 1.3 - 1.5" ID rail.
It appears to have a nitride finish, and the inside in machined well. Mine did not include a gas tube roll pin, so that's a drawback. The set screws are also flat face, they are not knurled. However, if you're planning to pin it, that won't be a problem
It is absolutely small enough to fit within a 1.3 - 1.5" ID rail.
Would Recommend:
Yes
2 of 2
found the following review helpful.