Reviews & Ratings for Strike Industries AR Modular Magazine Release — 7 reviews — Page 1

I love this magazine release set the only thing is there are no real instructions on how to change out the buttons, you can go on YouTube but I thought I’d share with you how I did it. When you install the only difference is instead of pushing from the other side and screwing in the button you screw in a flat nut, screw the nut in flush on the screw you will see the different buttons all have a square cut out with a raised cross section, while pushing in from other side slide the button onto the nut an whole installed. Know how do I take it off? Tho take it off Do Not Twist it, I read Reddit post and people saying to twist DO NOT. I used a string plastic knife or if you have a thin fine edge plastic plugger you have to do is with the button side up push down under the button to separate the raised crossed sections of the button and slide the the button straight off forward or backwards while pressing down. Then slide the new one on.
I hope this helps someone else. I broke a button twisting my first try, it is easy to swap buttons quickly after the first time, To Strike industries, if you are going to make a cool thing like this make a non mating little tool that comes with it to change buttons. Other than that love it

I installed it and thought WTH the buttons are ok. But if you push forward and in like most fingers do slightly it catches and jams up. You have to be dead on to drop a mag. I ended up ordering a plain mag release.

I love pretty much everythinf strike has to offer and this is no different so far! A bit of a pain on the install and because if that a little difficult to switch iut the buttons but nonetheless im currentky using the middle size which is comfortable and easy to engage...buying s secind one for my other build!

I love most of strike industries products and this modular mag release looked perfect for my SBR! Love the modular options although I do wish they were metal and not polymer but they are still seemingly durable. Installation is a little tricky trying to get the button nice and tight in the slot and threaded to the right point, especially with the large extended button because of it's not tightened most of the way down it tends to bend/tilt the whole system and it just doesn't quite feel solid that way! Wish you could purchase another adapter so I could run one of the other buttons on a different build but don't think that's an option. The middle size button is decent size and easy to reach and engage and I haven't had any issues with any mags locking or dropping. I definitely recommend!

Not a bad magazine release kit. Would like to see an all metal version instead of using plastic components, but all in all not bad. I would recommend these AR15 parts to anyone that is looking for quality parts.