It works as it should. - Strike Industries SI Oppressor

Just a heads up, if you purchase this item then there's a step or two you might wanna take before using the Oppressor.

I recommend using blue loctite on the small screws located on the mounting portion of the Oppressor. MAKE SURE TO APPLY LOCTITE ONE SCREW AT A TIME.

After the first use and 180 rounds later (60 round mag dump with a binary trigger) I noticed that the Oppressor was difficult to remove. Upon inspection I see that one of the screws had come out which made it difficult to remove the Oppressor. A small hex key wrench in the hole and a little adjustment made it much easier to remove and install.

I reached out to Strike Industries direct and was advised that this was an issue on the earlier batches. I requested from SI if they could send me just the screw and that I'd fix it myself, they ended up sending me a whole new Oppressor at no charge. Great customer service if you ask me. Now I have two Oppressors.