Not a good fit - Strike Industries Magazine Release for SIG SAUER P365

Very easy installation, but it just did not fit well in any of my P365 grips in my case.

It was very difficult to push in unless you pushed in and towards the front of the pistol. If I pushed the mag release perpendicular to the grip it would function at all. At times it would slightly catch when pushing the release button, even if pressing in and towards the front of the pistol as mentioned before.

When inserting a new magazine into the grip with the Strike Industries mag release in place it would catch on the opposite side of the mag release button (I'm righthanded so in my case on the left side of the inside of the grip). I could insert a magazine without hitting it if I slowly pushed it in with the magazine completely inline with the grip (if it was slightly canted at all it would catch). I could never install this in a carry pistol and as the fit and function are not optimal at all, and when looking at the high cost (23 dollars for a small part), you would be much better off spending your money elsewhere in my opinion.

I had this same issue tying to install in my factory XL grip as the Mirzon aftermarket grip, so it was an issue with a defective part, not the grip module itself (I also installed factory magazine releases in both grips with zero issues with fit or function).