by
Alex Li,
Verified Owner
from SC, United States
Written on June 23, 2024
Purchased 2, one for my AP5 and one for my PTR91. What an incredible improvement over the factory GI triggers! Light, crisp break, and short reset.
Pros:
- Short reset
- Crisp & clean brake
Would recommend: Yes
2 of 2 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
Adam Thronesberry,
Verified Owner
from OK, United States
Written on April 23, 2024
Mostly got this for the 922 compliance but the ease of installation and overall performance of the trigger really made me feel like I got my moneys worth. Works perfectly in my CETME .308 with the Magpul SL grip module.
Cons:
- Only con was thinning out the ejector arm to fit
Would recommend: Yes
0 of 1 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
Zachary,
from MS, United States
Written on November 23, 2023
The trigger is worlds better than the factory trigger on my SP5. Easy to install and fit well.
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
Black Rose,
from IN, United States
Written on November 8, 2023
Fantastic for my requirements. Works better than the trigger that came in item that I purchased. Very far much better. Cost is immaterial.
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
FB,
Verified Owner
from PA, United States
Written on September 30, 2023
A little sceptical after some of the early reviews, but absolutely no stuck resets or light primer strikes for me, what a superb trigger compared to stock. Works fabulously in my PTR9CT SBR, and was a breeze to fit. Don’t forget to lube it, dry as a bone in the box.
Would recommend: Yes
1 of 1 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
R Collins,
Verified Owner
from MO, United States
Written on September 21, 2023
Again, this is the second Timney I've purchased. Installed flawlessly on an original HK94. The difference is quite noticeable and much better than the factory. Recommend this product if your system can have it. Worth the dollars.
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
R Collins,
Verified Owner
from MO, United States
Written on September 11, 2023
I must say its been 35 years in the waiting for such a gem. Installed in on an original HK93. Very smooth and crisp compared to the original hardware. Presently waiting for my next one. Will be installed on an original HK94. Its worth the money. Installed unit in under 5 minutes with no issues.
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
Tom,
Verified Owner
from CA, United States
Written on September 8, 2023
Easy to install but rather expensive but I think this is your only choice to replace your trigger. Easy to install so no worries there but really Really expensive. Did I say really expensive? It's really expensive....worth it tho
Would recommend: Yes
1 of 2 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
Tom,
Verified Owner
from CA, United States
Written on September 2, 2023
This trigger although pricey, goes in like a snap! Even changing the hammer is just pop out a pin and dont lose on your old one and just pops in, slide it back in, push the safety in and done! So simple a child could dot it.
Cons:
- pricey (but u get what u pay for)
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
Peter,
Verified Owner
from FL, United States
Written on May 13, 2023
Competitor's trigger causes problems with ejector leading to jams. This trigger works 100%. Ignore bad reviews. It's a great improvement over everything else, adds four 922r parts for those of us who form 1, and it bumps. Something previously impossible with mp5 triggers. I think that OP accidentally mixed up prices bc the factory demos are listed as the more expensive product XD
Pros:
- Huge upgrade, 4 compliance parts, bumps
Would recommend: Yes
2 of 2 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?