Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
Most Helpful Negative Review
Very low profile, offset picatinny rail mount with one major limitation. OK if you can work around
It is very low profile. If they had made it about 1/8" or 3/16" higher, it would have been much more flexible because there wouldn't be interference between the screw that holds the unit in place and the 3 groove rail section.
It is offset with a 45 degree angle for the 3 groove Picatinny rail section: potentially very useful for a light mount, auxiliary sights, laser, etc.
What is not obvious from the product description or photos is the transverse screw that holds the unit in place on the primary rail will interfere with many mounts that you may want to use on the offset/angled 3 slot ra...
Read More...
Read More...
Offset Picatinny rail works ok
This is overall a decent offset rail however you do have to fiddle with it a bit to get it installed properly and it is solid but slightly less secure than I would like.
Would recommend: Yes
Low Profile
The low profile and craftsmanship are 5 Star. Worked perfectly for mounting my red dots for backups.
Pros:
- Low profile
Cons:
- None
Best Used for:
- Back up sight mounts
Would recommend: Yes
Doesn't work
The screw is too short to even fully tighten down so it doesn't actually clamp onto an existing rail. It straight up doesn't work. I don't really know what else to say but I have to have 200 characters to submit this so here we are.
Would recommend: No
1 of 1 found the following review helpful.
Does not secure to the rail.
The cross screw is too short. Only 3 threads would catch in the opposite side of the clamp, and those quickly stripped. This is not even worth the time it takes to order it. Pass hard. Words. words. words. words. to make up enough words to be accepted by this field.
Pros:
- None
Cons:
- Does not work AT ALL.
Best Used for:
- Trash can.
Would recommend: No
1 of 1 found the following review helpful.
Unable to secure to rail
It wasn't super expensive and it is low profile but I can't use the it at all because it is too large to tighten onto a standard rail. You can't tighten it enough to secure to the rail. The screw or housing doesn't fit so it's so loose it will just fall off even if you've fully tightened the screw.
Pros:
- None
Cons:
- doesn't fit mil-spec Picatinny rail
Would recommend: No
Offset mount
I do not recommend this mount. The dove tails fit poorly and the screw was way too long. I had to grind the screw shorter so it didn't interfere with the offset rail. I also had to grind the top of the clamp so it would hold tightly.
Pros:
- Cheap
Cons:
- poor fit
Best Used for:
- Mounting a light
Would recommend: No
Bad, bad bad bad
Terrible, flimsy and soft, no usable threading, just bad all around. The material is too soft to retain thread engagement with the screw which itself is too short and freely flops around. The rail on its own appears a bit too narrow for most accessory attachment types, leaving them loose and wiggly. Not terribly expensive so no big loss, but still disappointing.
Would recommend: No
1 of 1 found the following review helpful.
There are no reviews that match your criteria. Would you like to review this product?