Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
thomas's Review of Volquartsen Firearms CNC-Machined Bolt for Ruger 10/22 and 22LR
During installation of the bolt if the rod end comes out of the notch in the back of the receiver and the bolt slides forward, it will be stuck in the receiver. At this point you will have to bend the rod or cut it to remove the bolt.
You will then need a new rod and spring.
Every time you clean the gun you run this risk.
In my opinion it is not worth the risk and this issue needs to be resolved by Volquartsen.
Optics Planet why are you selling a part with this kind of known design flaw.
Why are there no warnings in the description of the product. I expect better...
You will then need a new rod and spring.
Every time you clean the gun you run this risk.
In my opinion it is not worth the risk and this issue needs to be resolved by Volquartsen.
Optics Planet why are you selling a part with this kind of known design flaw.
Why are there no warnings in the description of the product. I expect better...
Would Recommend:
No
17 of 59
found the following review helpful.