Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
Most Helpful Negative Review
Loose tolerances.
I tried to install these on 3 Ruger No 1s. Ruger rings were out of stock everywhere and I have had great success with Warne in the past. The first set were fine. The second and third sets keep shifting. It seems like the tolerances are just too loose. I get the rings on and tighten the lower screws to hold them on the Ruger integrated bases. Adjust the scope for level, eye relief and start to tighten the upper screws. This pulls the lower part of the rings open just enough to allow the rings to shift.
Perfect fit
Perfect fit on an older mini 14. A little tricky to install because they have to be mounted on the scope first and then to the receiver. But once realized that, No problem.
Pros:
- Perfect Fit
Cons:
- None
Would recommend: Yes
Warne 30mm ruger no1 rings
mount screws would not fully tighten on stainless Ruger No1. Factory Ruger rings worked perfect. Nothing else bt have Warne re-engineer their product. This review requiring 200 characters is plain BS.
Would recommend: No
3 of 3 found the following review helpful.
There are no reviews that match your criteria. Would you like to review this product?