Poor design - Wheeler Fine Gunsmith Equipment Delta Series AR Gas Block Taper Pin Removal Tool

A pin removal punch block that is designed without through holes on the other sides can’t be effective. Anyone that’s ever dealt with stubborn front sight taper pins could see the benefit a block that would perfectly align punches and be an “extra hand” for breaking the pin loose would be invaluable. This is a poor design and seriously missed the boat on the opportunity it had to fill a niche. The large starter punch is too large to go into the holes (which is generally where you need the most help in this application) and even if it would the other side of the block has no holes for the pins to be punched out through. The hole is also too large to “center” the finishing punch that drives the pin all the way through after the start. So in essence you’re trying to punch the pins out into a solid block on the back side. I’m very disappointed. This is the first wheeler product I’ve ever been disappointed with. Hopefully they will re-design it effectively.