Firesight for tapered barrel ruger mk11 - Williams Gun Sight Target Pistol Sights For Ruger MK-II & MK-III 6-7/8in Taper Barrel, Pre 2015

This sight is for the pinned on front sight of a Ruger MK 11 which is far different from the new screwed on front sight. The rear sight is the same for both. I purchased the set as they were cheaper than a new stock rear sight alone. Fantastic in daylight and outdoors in general. Not quite as nice in the dimmer light of our indoor range as a fair bit of ambient light is required to illuminate the light tubes to a vivid glow.
Rear sight install was easy. Front sight was a job that you may want to get a pro to handle. I took a small brad nail and drifted the tiny pin out of the front sight base and then, with some difficulty, pulled the front sight blade out of the slot. The new front sight blade had to be filed a bit to fit the slot and when it was able to bottom out in the groove, a mark was made with a brad on the sight blade, which was then removed, drilled and replaced. The original pin was tight and secure. I am happy with the sights. Their appearance and function are as high a quality as what I would expect from Ruger, Colt or Smith.