Wheeler 89-piece Deluxe Gunsmithing Screwdriver Kit 562194 gives you a full complement of the single-most important tool used in gunsmithing. The Wheeler Deluxe Gunsmithing Screwdriver Set is the kit that belongs on every gunsmithing bench - the well thought-out bit selection will put an end to burred, buggered, busted up screw slots on any gun that comes your way. The bits make up the heart of any screwdriver set, and Wheeler's are the finest available. Each bit in the Wheeler Gunsmith Screwdriver Kit is made from S2 tool steel and hardened to 56-58 Rockwell "C." Unlike other screwdriver suppliers, Wheeler's engineers measured the screws on over one hundred modern and antique firearms to make sure bits for every situation were offered.
Whether you're working on a Browning Superposed, a Remington 700, a Smith & Wesson revolver, or a Colt Single Action, you'll find that there's a bit to fit every screw on your gun in the Wheeler Gunsmith Screwdriver Kit. The 54 Hollowground flat bits range in size from .120"x.020" to .360"x.070", and includes doubles in the thinnest sizes. (Any gunsmith will tell you that you're occasionally going to break the ultra-thin bits on stubborn screws. This set includes two each of the very thinnest bits, which means you'll never be stuck in the middle of a job without the proper bit.) Wheeler 562-194 Deluxe Screw Driver Set also includes a complete selection of Phillips, Allen, and Torx bits to cover scope rings, bases, recoil pads, and the like. The set comes with two handles made from comfortable overmolded plastic; the first is a regular size handle that's good for most jobs, and the second is a slimmer, shorter "Close Quarters" handle that is good for finesse work with smaller bits. wheeler Gunsmithing 89 piece Screwdriver Set also come in a durable custom box that's ready for the bench or your range kit.