Reviews & Ratings for Kimber Optic Plate Kimber KDS9c to RMSc/Holosun K Adapter Plate — 2 reviews — Page 1

Kid you not, I just had the exact same experience as chuck.
I picked up a KDS9C and immediately found the Kimber factory optic plate in stock here and discovered the promo a day or two later and simply assumed it would be the Kimber plate included. By that time OP already had my plate in the mail so I intended to return it after receiving the other.

Turns out the CH Precision one that came in the promo was not nearly the quality standard I was expecting. I preferred the CH Rear Sight on the plate, but it was a bit loose to the slide cut and uses loose nuts instead of threaded holes in the plate itself. After installing and realizing I missed placing the nuts into the slide prior, all 4 of the screws stripped as they were a REALLY soft aluminum.

The Kimber brand plate is a night and day difference in terms of quality. The rear sight is not bad at all, just a little lower than the CH, but all tolerances were tight even before screwing down, and came with much higher quality hardware.

If you can find them, but this plate over the CH Plate - you will be much happier with the durability.

This is the optic by Kimber for the Holosun K models. I purchased A Kimber KDS9C in April and was unaware of a promo they had going on until I registered it with them and you could sign up for a free holster, Optics plate, 18rnds Mag and Mag holder . It seems that Kimber has a company called CHPWS.com making their optic for the KDS9C as they are out of stock of their own.... This optic from optics planet is much nicer than the CHpws.com optic because theirs has no rear sight adjustment. and is thinner . I was going to return the plate after I received the free plate but not after seeing it the original Kimber plate here at optics planet is the way to go!