Your Browser is Outdated
Yes, this should line up with the Elcan Specter series of sights.
Yes, the Trijicon Electro Optics SNIPE-IR 35mm Clip-On Thermal Imaging Monocular sits at the same centerline height as a 4x32 ACOG optic, about 1.5".
Please email us at techsales@opticsplanet.com regarding your questions for the Trijicon Electro Optics SNIPE-IR 35mm Clip-On Thermal Imaging Monocular.
The Trijicon Electro Optics SNIPE-IR 35mm Clip-On Thermal Imaging Monocular is compatible with 2.5x-10x up to 4-12x variable sights. So essentially 12x would be the max magnification this monocular would function with.
The Trijicon Electro Optics SNIPE-IR 35mm Clip-On Thermal Imaging Monocular will be compatible, however, Trijicon has a day sight compatibility chart for variable optics stating it will only work well up to 12x.
Hi,
The Trijicon AccuPower will be one of the best to use with.
https://www.opticsplanet.com/s/trijicon-accupower
Thank You.
Yes in good and in bad sense. The good is that it aligns perfectly with any scope with the same height as to ACOG, i.e. VCOG, Elcan and so on. The bad is that it is designed to show 1x picture when a 4x scope is behind, i.e. ACOG and Specter becomes 1x scope and VCOG becomes 1-1.5x scope.
It all depends on rings. If, with rings, the scope axis is 35-40mm above the rail, it should (and I, suppose, it is possible to find rings low enough to but x50 scope that low).
However, with 6.5 minimum magnification, you may be not able to see all menus, the screen is optimized to be visible full size at 4x and all menus are displayed at very side of it.