Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
BH Oversized Trigger Guard for AR-15
Purchased for install on AR lower for Winter Hunting with heavy gloves. Did not have sharp edges as noted by other reviewer. Finish was acceptable and item within factory specs for fit. Installs using 2 roll pins, unlike standard guard using 1 plus static spring loaded pin. Permanent install untrue! Can drive out pins and re-install original guard if desired.(Why?) Replacement took less than 5 minutes-have proper tools to avoid blemishes to lower. I recommend this guard as a good option for my intended use.
Pros:
- Fit and finish
Cons:
- Minor skills required for installation
Best Used for:
- Gloved hands
Would recommend: Yes
Poor quality on many levels..
This trigger guard has 3 big issues:
1- razor sharp edges
2- uses push pins to install and can not be removed
3- non reaponsive manufacturer CS
Edges needed to be filed and forward pin needed to be replaced with an insert allan screw.
Sent an email to manufacturer CS and had no reply.
Skip this one and get a better quality item for a few more dollars.
1- razor sharp edges
2- uses push pins to install and can not be removed
3- non reaponsive manufacturer CS
Edges needed to be filed and forward pin needed to be replaced with an insert allan screw.
Sent an email to manufacturer CS and had no reply.
Skip this one and get a better quality item for a few more dollars.
Would recommend: No
2 of 3 found the following review helpful.
There are no reviews that match your criteria. Would you like to review this product?