Reviews & Ratings for BOG M-LOK Arca-Swiss Tripod Plate — 7 reviews — Page 1

Very nice quality for a budget price. Can’t go wrong with this plate

This is my fourth different manufacturer of m loc arca Swiss tripod plate. This BOG IS the only one I have to adjust my accu tac bipod to get it to go on. Then when you do get it on the angel milled in the plate is not the same as the mount do yourself a favor and save you some headache and don't buy this junk

Rail is very light a full 12",all hardware needed. Works great on ar10 16" handguard. Had to shorten bolts for heavy barrel. Great rail for the price, I got 3

I mounted this to my Ruger Precision Rimfire. I was looking for a 12” Arca rail and could basically only find 11” rails from unfamiliar brands and those were double the price. I’ve owned a few BOG products and decided to give this a shot. This nearly fits the full length of the handguard and will allow me to move my bipod rearward now when shooting at my local range. Their benches aren’t as deep as I’d like and prior to purchasing this Arca rail, my bipod was at the very end of the handguard and would almost slip off the bench if I wasn’t paying attention to it. This Arca rail will allow me to move my bipod rearward when I’m at that range.

My only complaint is similar to that of the other reviewers mentioning hardware. The screws were a bit long and would make contact if any pressure were applied to the handguard like when loading a bipod. I understand it has to be challenging to find the perfect screw length with so many M-LOK handguard and rails out there having different specs. The handguard that envelopes the barrel on the Ruger Precision Rimfire is pretty tight-fitting so handguards that have a larger diameter might be fine. It was a simple enough fix and I just cut a couple threads off the screws. Though I do think it would have been nice for them to include a few different screw lengths.

I did not have any T-nuts break, but I did notice that they didn’t want to perfectly cam over at 90*. They wanted to be slightly off from that. I’m not sure if it’s a T-nut spec on t...
Read More...

The alum is milled well for arca. But I had to take off rail for a bit to mount something else on my hardguard and while I was taking it off one of the mlok nuts broke. wtf. At least replacements for those are easy to come across

Does it's job and holds well to ARCA accessories. Biggest complaint is that the mlok nuts are slightly out of spec (camming area a little too large) so you might have to sand those down to get them to rotate the full 90º depending on your handguard. Also if you're running a thicker barrel on your AR-10 you might have to shorten the screws and even the mlok nuts. I'm running a BA Hanson 20" heavy fluted barrel with a 15" handguard and had to modify a few of the screws to clear the barrel and gas block.