Reviews & Ratings for Bravo Concealment IWB Torsion Holster W/ Waistband Clips — 6 reviews — Page 1

I think this is a fantastic holster. Especially for the cost. I have tried several other holsters that cost 4 times as much and prefer this one. Really great value! Great quality. No downside at all. Fits both Glock 19 and Palmetto State Armory’s Dagger with suppressor sights

I just purchased a Springfield 1911 Garrison and needed a holster that accommodated the wider thumb safety lever that is on the Garrison. The fit is near perfect. Draw is clean.

For the price, I'm not sure you can get better fit and quality for a Springfield 1911.

I have carried many guns and holsters. Even a 1911 in a nylon holster does not catch as badly upon reholstering as the Glock 19 version of this IWB holster. Plastic holsters are always a little loose, I get it, I own others - but this is simply improperly formed and does not make enough contact to grip. These two factors make this holster dangerous and I strongly recommend against it. A round in your thigh is much expensive then spending a little more on something functional.

It also holds the gun unusually high, resulting in unacceptable printing. The plastic belt loops are too small for any belt I own except for a cloth web belt. There is no backing at all so it is constantly rubbing against your skin and is miserable to drive with. I purchased this thing because it was all the LGS had in stock for a Glock 19. Should have just ordered something better online but I hope you don't make my mistake.

i have just discovered the bravo concealment 2.0 iwb torsion holster and ordered one for all of my concealed carry firearms , the dual clips are set very wide which makes the holster very stable on my nexbelt edc gunbelt , the opticsplanet advertisment does not give an adequate discription of the holster so i went to the bravo website and did further research and have found them to be an excellent value and have since purchased several more holsters , highly recommended.

I bought this because it said it wood fit “full sized” p320. Sadly the slide is too long for the holster. I suppose that one could cut out the portion of the holster that covers where the end of the barrel so it COULD fit all the way in, but I’m concerned that it would make it chafe.
SIDE NOTE: I’m not a fan of their “Torsion technology”. I’m going to try a “wing” style concealment holster next time.