Gordon from United States, OR Public Profile

After trying out this barrel which is a really good price point, I am more than happy on my Gen 3 Glock 21 with superior to factory accuracy, ability to handle my lead bullet loads and the threading for accessories . I actual got this barrel because it took a compenstaor and has better chamber support than factory Glock barrel. It fit very nicely with good finish . I built is as a .45 Super host with stainless spring guide and heavier 22 pound recoil springs. I load in .45 Super cases moderately heavy loads with 230 grain lead bullets at just over 1000 FPS with a Compensator for bear protection . I could not be happier with the results of this barrel .

I bought one of these for an AR10 build using all Aero parts. I is very light and reasonably crisp. But I found a dangerous defect and will explain why : I first put this trigger in an all Aero Ar-10 .308 build I did in 2019, bought from Optic Planet. I had a great feel and allthough a pain in the neck to fit exactly as instructions advised, it fit. On my first outing with the build one time I was seated at the bench ready to fire first shot down range the gun fired when I flipped off safety ! I determined after testing and cleaning my shorts, that if you squeezed trigger with safety on , some times it will discharge when safety was push to off. I took the build completely apart many times trying to rectify this and shimmed and adjust it many time. I pulled it out and put in a La Rue trigger and never looked back on the AR10 .308. This year I built an complete Aero AR10 in 6.5 Creedmore with a heavy long barrel and remembered the Rise trigger that never worked in the other one and decided to give it a try as it was a range gun and the trigger IS very lighht. I fitted it perfectly using new screws and it di the same thing. I studied the trigger on the bench and saw it had the trigger reset screw installed with a snapped off head so it could not be adjusted , I determined that setting was the problem ! I managed to remove that snapped of by factory anti tamper adjustment and by screwing it in, making the pull a little heavierer and increasing the reset weight it would functio