J.S.T. from United States, CA Public Profile

Handy little knife. Its m daily go everywhere do every thing. Not expensive. If you want it get it before boker discontinues like they do with the good ones...

I got one of these on the Dvor side of optics planet. HEAVY wall,doubled in the fire box. Stainless rivets. 1/4 inch thick mild steel grill plate. Stout! Even the vents are built like this. ALL the accessories are unobtainium at his point since the company that built them went bankrupt. These cost over 800$$ when they were retailing. The 2.5 times bigger version with a cart went for 4000$. These are a deal on here right now. Any accessories you might need is available IF you can read a tape measure and adapt what you need from other sources. GET the smoker plate. This thing can be set up as a smoker to. I sourced a cast iron griddle, stainless charcoal tray, extra stainless grills and a stainless table ALL off temu for less than the cost of the factory cart that goes with this. You can do it to. Charcoal only. No gas. As it should be. When they are gone,they are gone for good.

All the usual suspects are in here. Laughed really hard when I noticed the bandaid in the bag. Clearly produced by men who have put tiny roll pins in without the right punch. I bet they have a bad temper about it at first to. My kind of people.

The tigers eye tint works in low light and direct sunlight. Optically neutral or close to it. I own much more expensive eyeware that is not as good as these (looking at you BREED ) . XL really means XL with these. Military Ballistic MCEPS GL-PD 10-12 is a GOOD rating for shooters. Wife says when I wear them that I look like I should be named Dieter and be wearing black latex gimp suit and sleep in a box in a dungeon. My next wife will be of a different opinion. And be thinner.

Ive been using these for years. Never any kind of issue. Tried a cheapy I had in the drawer. Leaked gas like mad past the seal rings. Checked the tolerances and it was out of spec and ROUGH machining. I should have checked this before using it. Had to replace it. Went with what I have had nothing but good experience with. Checked the dimensions (spot on) and installed a Lantac domed cam pin and JP spiral ring. Never be a problem again.

Seamless taper from 1 inch to 2 inch. Neat trick. Built in padding. AR10s get heavy in a hurry. Even at two inches wide, you will still feel it after a few miles. Top of the line build quality. Nothing else like it. Adjusts easy. Real easy. Can work with an Ace SOCOM stock with no QD hole as is. Long enough to be configurable to what ever you or the high speed low drag crowd can come up with.

I have these on everything I own. Very handy little lever. I have V2 and V3s No issues with either one. Way stronger than it looks. Can take out trigger pins without removal. Best of its type.

Well made. I own 9 Nanuk cases of various sizes. Best Ive found. The latches are better than the others I own. And either come lockable or can be upgraded. As tool cases,these will keep dirt and water out. And take a real beating. Never had one fail in any way yet.

Close to theft at the price I paid. Very well made. No issues at all except the battry. Needed a cr123 battery instead of the camera cr2. Only serious oversight.

I really wanted to like this thing,but the plastic is ALL cheap. Every plastic part on this thing flexes out of shape easily. The cheap metal (sic) reinforcements, dont. The rubber clamp faces are already splitting. The magwell post is a pathetic joke. And so is the wheeler AR-10 version. Literally every plastic part on this is not worth throwing away,much less paying for. SAD...