Your Browser is OutdatedReviews by Jay
Required for Noveske 18" Barrels
Written on Jun 21, 2020
Review for
Noveske Gas Tube Pack
I needed the intermediate length gas tube for the Noveske SPR 18" switchblock barrel. Instead of the usual carbine and rifle length gas tube, this particular barrel needed the intermediate length. Ordered from opticsplanet and arrived promptly, fits and functions perfectly.
Same as the tool that was shipped with the optics
Written on Feb 12, 2020
Review for
Vortex L-Tec AMG Turret Tool
I misplaced the L-Tec tool that shipped with my Vortex Razor AMG scope and this is a perfect replacement. Please note that the photo listed on the site for the tool showing a flat head side is incorrect. One end of the tool is a hex wrench, the other end is polymer for opening up the screwed cap of both windage and elevation turret.
Works well
Written on Feb 12, 2020
Review for
Ultradyne Apollo Max Compensator
This muzzle brake was installed on a 308 with 16" barrel. Recoil was greatly reduced to the point where it is very manageable. Overall impressed with the quality and finish. The timing nut is easy to use. However, there is still quite bit of a muzzle rise on my rifle, I wish this brake can reduce muzzle rise better in the future versions.
7 of 7 found the following review helpful.
Works as designed
Written on Feb 10, 2020
Review for
TANDEMKROSS Halo Charging Ring, SW22 Victory
I installed this on the SW22 and it makes charging a lot of easier. The fit and finish are both superb. Installation was very easy and literally took less than a minute. Will probably black out the logo on the charging ring at some point.
Great Reddot
Written on May 15, 2017
Review for
Ultradot Matchdot II 1x30mm Reflex Dot Sight
This is my first bullseye red dot sight. I use this on top of a les baer 1911 with optics mount and the red dot works great. Options for the red dot and sizes and brightness levels are great. The dot was easy to zero and seems to hold zero very well.
1 of 1 found the following review helpful.
Great Rings
Written on Nov 24, 2016
Review for
Leupold Mark 4 Mounting Rings
Have 2 pairs of these on my .223 and .308 rifles, high quality rings. I prefer these to vortex precision rings and burris. I did use locktite on the 4 screws. No issues with unmounting and remounting.
Great Bipod
Written on Nov 06, 2016
First of all, the legs can have some play in them. There is an easy way to fix that issue. Remove the legs and a torx screw is revealed, tighten it and the play goes away! Felt cheap before I did that, felt great after that. Easy to load and feels sturdy.
I used this bipod on a 223 gas rifle and shot in 600 yard prone competition, scored 199 for 20 shots. Obviously the bipod is only part of it.
I used this bipod on a 223 gas rifle and shot in 600 yard prone competition, scored 199 for 20 shots. Obviously the bipod is only part of it.
1 of 1 found the following review helpful.
Fits and Feels Great
Written on Aug 04, 2016
Installed these on a Daniel Defense M4 v7 with M-Lok handguard. The panels feel great to the touch. Installation and removal are both easy. To install, align the panel to the m-lok slots and push in the strip until flush. To remove, pry the strip out using a small flat head screwdriver or a punch. High recommended.
7 of 7 found the following review helpful.
There are no reviews that match your criteria. Would you like to
reset filters?