Reviews by Jordan Hunt
on my votex DB 4-16
Written on May 30, 2024
Review for
Midwest Industries High QD Scope Mount
I like it. I have used it for ar10 and 15. Seems solid. I would go by your scopes torx spec. The diamondback called for 18lb, the mount wanted like 25lb.
0 of 0 found the following review helpful.
its good for duty/range
Written on May 17, 2024
Id get the mid ride. The hood is a little annoying. But id run it open for the best preformace. With it all locked up, its kinda tought to defeat. But practice
0 of 0 found the following review helpful.
interesting
Written on May 09, 2024
Review for
SIG SAUER BDX Combo Kit Sierra3BDX 3.5-10x42mm Rifle Scope w/KILO1600BDX Laser Rangefinder
Bought this to shoot with my dad because its hard to explain everything. He aint getting younger and we just want to shoot.
0 of 0 found the following review helpful.
watch your handguard
Written on Oct 20, 2023
Great barrel. Attractive, accurate, lite for profile. But be careful with skinny handguards, specifically aeros slim line. It is just about resting on the gas block. Im getting about 1.2"@100yd. But im sure it whips into the handguard. Not a fault of the barrel, obviously. But im sure itll tighten up after i get the proper ID handguard.
0 of 0 found the following review helpful.
doesnt fit
Written on Aug 24, 2022
Review for
Magpul Industries M-LOK QD Sling Mount
Bought this along with the magpul sling that already came with qd. The hole one this is too small. The qd on the sling fits all my other qd mounts. Its a pain to figure out after dealing with mlok. Shame because it looks nice but if it doesnt work. Its just a bad hole.
1 of 2 found the following review helpful.
good and over built but miss leading
Written on May 04, 2020
Review for
Cross Armory Big Bolt Catches
I bought this for an ar10 build. It does not work. At least for an aero ar10 lower. It was flush against the ar10 lower and didnt pivot at all. This is the only reason I didnt do 5 stars. I put it on one of my ar15 lowers and worked great. It is a little bulky, but functions great. It seams to hold the BCG to the rear a lot better then the magpul bad lever. I like the bad lever system, but it always bugged me that it was a little bit of a slacker. If you shook the rifle, the bolt would send home. This bolt catch holds the bolt unless you hit the rifle, which is predictable and there for fine by me.
0 of 0 found the following review helpful.
There are no reviews that match your criteria. Would you like to
reset filters?