Your Browser is OutdatedReviews by Jesse Sellers
LR.308 Bolt
Written on Nov 03, 2024
I actually used this bolt on a 6.5 creedmoor build and it worked great. I had a coupon and a few OP bucks to spend so I got this one. Headspaced great to the rifle and had extraction and ejection.
1 of 1 found the following review helpful.
Presma action rod
Written on Oct 23, 2024
Not a bad tool for the price. It’s not a tool you’ll be able to build a dozen .308 pattern rifles with, but it will build a few. If you want a pro tool then go spend more money!
Presma action rod
Written on Oct 15, 2024
Tool worked the way it should. I added some thin tape to the chamber interface to get rid of a slight wiggle. If you’re not building a lot of rifles this tool will work out fine. If you are spend the money and get a professional grade rod.
1 of 1 found the following review helpful.
Extended magazine release
Written on Dec 20, 2023
This will help get you out there where you need to be on your mag catch. I used this with a .308 mag catch and the extended button gets it right where you want it.
.308 mag catch
Written on Dec 20, 2023
Review for
Luth-AR .308 Magazine Catch
Some of these .308 builds can be a pain. Sometimes you need a little bit more length on the mag catch. It’s only a hair longer, but with an extended button release it’s perfect!
AR style end plate
Written on Dec 20, 2023
Review for
Luth-AR Carbine Latch Plate
Unless you’re one of those folks that has to have a tricked out plate with sling loops or quick disconnects these are fine. Don’t need to spend to much dough on and end plate when you can put it towards something else.
Anti roll pins
Written on Dec 20, 2023
You can’t beat these for the price! I use these on every build I do weather it’s ar15 or large frame spec. Especially on 80% builds they work great! Easy to install and they look great!
1 of 1 found the following review helpful.
.308 Bolt Catch
Written on Dec 20, 2023
Review for
Luth-AR Bolt Catch .308
Used this for my DPMS gen1 build. Worked great. Seems of good sturdy quality so far. I hate racking up money on .308 builds on these smaller components they tend to get expensive by the end. Save your money for the more important parts like BCG, barrel, receiver sets. It’s not a Gucci part, but it works well and looks the part.
3 of 3 found the following review helpful.
Bolt catch screw
Written on Dec 20, 2023
Review for
Luth-AR Bolt Catch Screw .308
Just another part on a .308 rifle that should not cost much. Good price on the part and as usual ordered enough stuff for free shipping! AR10 and LR.308 builds can get expensive so saving a buck or two where you can helps.
Large frame take down and pivot pins
Written on Dec 20, 2023
Used these on a DPMS gen1 build. They worked pretty well. They weren’t anything special, but they got the job done. The price was great. You know a .308 build can get very pricey by the end, so anywhere you can shave a couple of bucks off without sacrificing anything is a plus.
There are no reviews that match your criteria. Would you like to
reset filters?