Larry from United States, TX Public Profile

Fit and finish is cheap. The screws strip easily. Ended up replacing with Magpul polymer rails, and they are leaps and bounds better constructed than these. Another case of you get what you pay for...

This are nice sights, very light, and really the only problem I have, and it may just be my set, is that the rear sight aperture "large" hole is off center. It's offset to the right about 1/32, and down a hair. The "small" hole looks pretty well centered. So much for "precision CNC milled apertures."

I have a feeling that the aperture will always stay on the "small" hole on my set.

Also on the rear aperture, they advertise that they use one with a flat side towards the shooter, and it is, but it basically just looks like they took a standard aperture and flipped it over so the concave side is facing forward.

I think given the price for a set of fixed sights, and the importance of the apertures being centered, that these are not quite worth the money. But again, that could just be my set. Also I don't see where I can get tritium apertures or front posts, so that's a limitation too.

I really wanted to like these sights a lot, especially given the cost, but overall it leaves me feeling about like getting a new Corvette, but someone had replaced the engine with an 80's 305 out of a truck...