Your Browser is OutdatedReviews by Les
Fits MAC 1014
Written on Aug 28, 2025
Snaps into bolt and rotates easily. Works the bolt with a comfortable grip. It is difficult to remove, needs a tool for prying.
edge to edge clear red dot.
Written on Jan 18, 2025
Mounting was easy, it came with several different sets of screws so I could pick the correct thread pitch, diameter and length. It also came with a 1deg. mounting plate. I fits perfectly with the plate which puts the dot closer to mid range in the vertical adjustment. It also came with a pickitinny adapter. I checked the parallax, the dot aligned with the target and stayed crisp inside the viewable area of the sight. I like the battery placement, no need to remove the sight to replace the battery.
wouldn't zero.
Written on Nov 15, 2024
Review for
SIG SAUER Romeo Zero Red Dot Sight 1x 6 MOA
I installed it and it was very tight going on. The windage would adjust with a noticeable clicking, but the elevation had no resistance and wouldn't adjust at all.
Trybe gas block tube alignment problem
Written on Jul 31, 2020
The gas block looks good but I tried installing the gas tube, the Trybe gas tube and the Trybe gas block pin holes don't line up. I don't know if it's the gas tube or the gas block or both that's the problem. The gas port holes line up correctly. I've installed many gas tubes before, the roll pin drives in easily, but this time it went in halfway and stopped. Upon examining the gas block closely I found the pin holes were misaligned. I can't use it in this condition.
Trybe gas tube alignment problem
Written on Jul 29, 2020
The gas tube looks fine, it is the correct diameter and length. I tried installing the gas tube, the Trybe gas tube and the Trybe gas block pin holes don't line up. I don't know if it's the gas tube or the gas block or both that's the problem. The gas port holes line up correctly. I've installed many gas tubes before, the roll pin drives in easily, but this time it went in halfway and stopped. Upon examining the gas block closely I found the pin holes were misaligned. I can't use it in this condition.
7 of 7 found the following review helpful.
There are no reviews that match your criteria. Would you like to
reset filters?