Your Browser is OutdatedReviews by Lok
Original parts from Beretta 92 FS don't fit
Written on Oct 31, 2025
The safety does not come with any detents or springs.
I took out my old safety and salvaged the 2 detents with their corresponding springs and the firing pin safety.
I discovered that the larger of the two detents, the one closest to the left safety lever does not fit the hole in the Wilson safety.
The hole is stepped, a larger hole leads to a smaller hole at the other end, and it's this smaller diameter hole that is out of tolerance and was drilled too small.
Therefore, the stepped detent does not fit fully in the hole, rendering the safety unusable.
The tolerance on the firing pin hole is also not quite right resulting in a very tight fit.
Had to return the product.
I took out my old safety and salvaged the 2 detents with their corresponding springs and the firing pin safety.
I discovered that the larger of the two detents, the one closest to the left safety lever does not fit the hole in the Wilson safety.
The hole is stepped, a larger hole leads to a smaller hole at the other end, and it's this smaller diameter hole that is out of tolerance and was drilled too small.
Therefore, the stepped detent does not fit fully in the hole, rendering the safety unusable.
The tolerance on the firing pin hole is also not quite right resulting in a very tight fit.
Had to return the product.
Construction good, functionality not great
Written on Jun 23, 2025
The construction of this buttstock is as good as any other out there, very good quality, built to last.
The spring is rather strong, I have not had time to test it on the range, however I am of skeptical the claims that it will significantly reduce recoil because of the stiffness of the spring and length of travel.
The main point I want to make is the overly large and high cheek weld attachment renders the shooters head out of position to look down the scope.
I have this set up on an AR with EOTECH red dot and Vortex 3x Mini Magnifier.
With this stock installed replacing a standard Magpul stock, I found it impossible to look through the Magnifier because my head is out of alignment due to the cheek weld.
I ended up removing the cheek weld which defeats the aesthetics
The spring is rather strong, I have not had time to test it on the range, however I am of skeptical the claims that it will significantly reduce recoil because of the stiffness of the spring and length of travel.
The main point I want to make is the overly large and high cheek weld attachment renders the shooters head out of position to look down the scope.
I have this set up on an AR with EOTECH red dot and Vortex 3x Mini Magnifier.
With this stock installed replacing a standard Magpul stock, I found it impossible to look through the Magnifier because my head is out of alignment due to the cheek weld.
I ended up removing the cheek weld which defeats the aesthetics
There are no reviews that match your criteria. Would you like to
reset filters?