Your Browser is OutdatedReviews by Mike
High quality built like a tank
Written on Nov 21, 2025
Review for
ACCU-TAC Sr-5 G2 Arca Spec Qd Bipod
I love these bipods. I know have 3 of the Accutac and several of the Atlas. When you take this thing out of the box you can see the robust quality of the build. Heavy duty, tight and they just work great. I love the sled feet as well. I also like the atlas and find they both have their pros and cons. For a heavy magnum build, I think this is the way to go. If you want a quicker deploy then maybe go atlas. I'd really like to figure out how to get my Barrett 99 fitted with one of these.
Great ring but they don't work on everything
Written on Nov 21, 2025
Review for
Area 419 Match Scope Rings
I bought 2 sets of these. The first set was for a 6GT build and they worked amazing. I really like the pin guided clamps and the low profile clamp to the base. However, the second set I bought was for a my defiance action with a integral rail and when they arrived I found the rings would not clamp tight to the rail. I reached out to customer service and didn't really get much in response other than "do you have the clamp the right orientation?" I did. I ended up returning and replacing with Nightforce rings and they clamped right down on the same rail. I am not saying not to buy or that I wouldn't buy them again, but be forewarned they may not fit every rail.
A must have for long range
Written on Nov 21, 2025
Bought one of these after shooting with a buddy that had a different brand of lights that where a bit flimsy. This looked pretty solid and I liked the low profile of the lights on the side. It works great. We where shooting a mile and easily see it light off even in daylight. It will light up if you hit your target stand, but not much you can do about that be be a better shot ;). Great product and good value.
Good Quality a bit pricey but I'd buy it again
Written on Nov 21, 2025
When I was looking at options for a brace, I chose this one based mostly on the appearance over the SB brace. I am happy with the purchase. The folding mechanism is a bit stiff. Perhaps it will break in a bit, but would rather have it stiff then flimsy. Seems to be a good product.
1 of 1 found the following review helpful.
Misleading title
Written on Sep 08, 2025
The title of this is "Complete upper receiver with flash hider", however it shows up without a BCG or charging handle. Not exactly priced at any screaming deal without the BCG. If you read further in the description it does say they are not included so I suppose that is on me, but still disappointed that I waited months for OP to finally ship this thing only to get an incomplete upper receiver. 3 start for the crappy description.
3 of 4 found the following review helpful.
This is by far my favorite scope for a hunting rifle.
Written on Jun 27, 2024
I bought my first LHT a couple years ago for a custom hunting rifle build. When I was looking for scopes, this one just seem to check the most boxes. power range, capped windage, locking elevation, glass etched reticle, MOA designations instead of some garbage BDC, and the big one: Weight! This scope performs. Good eye releif, good eye box, good glass. It seems to be about the perfect comprimise of modern scope scailed for a hunting capable weight. I now have 3 of these. I would love to see a special run of this in a gloss and silver finish.
Great set up for the price, these are my go too's for 1911 trigger job
Written on Jun 27, 2024
Review for
Ed Brown Products 1911 Trigger Pull Kit
I love using the Ed Brown parts. I have usually just bought the hammer and sear but this time grabbed the kit. I like the look and feel of the hammer over most stock stuff that feels or looks like mim or cast. One note that I have is that I usually have to replace the safety with the kit, and you do have to "fit" a safety when you install it. I have this setup on some competition pistols and can tune the trigger to a crips ~2 lbs, and also can tune it a little heavier for others but keep that crisp break by tuning the 3 leaf.
2 of 2 found the following review helpful.
Decent, but a little overpriced
Written on Jun 27, 2024
I really like wood on a firearm compared to plastic. Figured I'd give the woox stuff a try despite feeling it was a little overpriced. The fit was good and it came with the tool you need to swap it out. They also have a youtube video showing the install. It is a bit bulky compared to the original forend. I would figure they need a little bulk to accomodate the mlok. Overall I am happy with it.
1 of 1 found the following review helpful.
Good value
Written on Jun 21, 2024
Review for
Aero Precision AR15 Rifle Buffer Kit
I still prefer to run a traditional A2 stock or magpul prs on accurized AR's. That said I need full lenght buffers. This one worked fine and was reasonably priced. No complaints
There are no reviews that match your criteria. Would you like to
reset filters?