Your Browser is OutdatedMr Fawkes from United States, UT Public Profile
Reviews by Mr Fawkes
Best small upgrade
Written on Feb 13, 2024
Review for
Wilson Combat Dome Head Safety
I find these 100% necessary for a defensive 870. The factory safety is too small and awkwardly placed,this fixes that
Renders the rifle innoperable
Written on Feb 07, 2024
When installed with no sling there's enough space between the loop and forward assist to get a sheet of paper in between, but not enough space for an index card. This means that with my sling installed the forward assist is pressed into the tweets just enough to lock the bolt closed. I didn't think it was possible but GG&G really screwed the pooch on this one.
Standard Magpul Excellence
Written on Aug 29, 2023
The K2 is good but not large enough, the K2+ is better but overmoulding does ugly things in the desert heat. This however is perfect for my hands. The K2 angle is better than the A1 in every way. If you don't have large hands this will probably be too much for you.
I always use the oil bottle storage pod and this one comes with one, saving me fifteen bucks.
I always use the oil bottle storage pod and this one comes with one, saving me fifteen bucks.
Lighter and better looking than mil-spec
Written on Aug 29, 2023
This replaces a boring steel mil-spec dust cover and after adjusting the detent to my upper that I didn't realize was so worn.
The mil-spec + spring + Rod + C-clip weighs 0.742oz, this all-in-one is 0.4oz. It isn't much weight but when you do this to all of the small parts it adds up quickly, in both weight and money.
The mil-spec + spring + Rod + C-clip weighs 0.742oz, this all-in-one is 0.4oz. It isn't much weight but when you do this to all of the small parts it adds up quickly, in both weight and money.
1 of 1 found the following review helpful.
Perfect if it were 1/4" shorter
Written on Aug 29, 2023
The button is a bit less than a quarter inch taller than mil-spec, screw pockets threads end a quarter inch short of bottoming out. These two issues compound to make the button stand nearly a half inch proud of the bump fence.
Fortunately for me I own a #10-32 bottoming tap, a Dremel and a spare mag catch so I'll make it work.
Fortunately for me I own a #10-32 bottoming tap, a Dremel and a spare mag catch so I'll make it work.
There are no reviews that match your criteria. Would you like to
reset filters?