Richard S. from United States, CA Public Profile

I use these in all my builds. Especially in higher end builds, why go cheap. Made in USA and more resilient to corrosion.

I had recently purchased all Tactical Solutions components, complete bolt & receiver assembly, barrel, & the XRT trigger. All this was intended for a Kidd chassis but did not fit. I wasn’t disappointed because “tacsol” discloses there could be fittament issues due to differences in tolerances among manufacturers. Looking closer at the trigger assembly, I noticed the trigger pin is too wide by several thousands and pushes the removable side plates out making it difficult to install in different chassis systems. I also had ordered an extended X-Ring mag release for this trigger. Luckily I studied how trigger is designed and assembled, and noticed installation of mag release is not “straight forward” as most other 10/22 triggers. The Tactical Solutions mag release did not fit into this XRT trigger!!! The original release installed easily over and over. I noticed there are small differences at the pivot point between the 2 releases. Warning to all, do not attempt working on this trigger unless you have some gun smithing experience. Now I was disappointed �

I have several New Frontier uppers and lowers. This is my first G2 upper and the fit and workmanship is outstanding only lighter. Also it’s made from 7075 aluminum good stuff. Also the LRBHO feature is a plus allowing me to use on my older JP.