Disappointed - Tactical Solutions XRT Trigger Assemblies for Ruger 10/22 and X-RING Rifles

I had recently purchased all Tactical Solutions components, complete bolt & receiver assembly, barrel, & the XRT trigger. All this was intended for a Kidd chassis but did not fit. I wasn’t disappointed because “tacsol” discloses there could be fittament issues due to differences in tolerances among manufacturers. Looking closer at the trigger assembly, I noticed the trigger pin is too wide by several thousands and pushes the removable side plates out making it difficult to install in different chassis systems. I also had ordered an extended X-Ring mag release for this trigger. Luckily I studied how trigger is designed and assembled, and noticed installation of mag release is not “straight forward” as most other 10/22 triggers. The Tactical Solutions mag release did not fit into this XRT trigger!!! The original release installed easily over and over. I noticed there are small differences at the pivot point between the 2 releases. Warning to all, do not attempt working on this trigger unless you have some gun smithing experience. Now I was disappointed �