Swanner from United States, WI Public Profile

These are by far my favorite anti-walk pin set on the market and the only set of pins I will be going with for all future builds - previously used JPs anti-walk pins for trigger installs. I liked them so much I even bought an extra set to replace a house brand set of traditional pins I used that did not live up to their rep (marred very easily). If you are building a traditional trigger setup especially one you can tinker with, as in manipulate the reset and overtravel, like my preferred jp enterprises triggers (https://www.opticsplanet.com/jp-enterprises-ar-15-154in-small-pin-trigger-kit.html) I think you need to go no further than these as you will not get a better product. My two favorite things about these: 1. The pins have recesses for the trigger, hammer, and j springs (or JP's speed springs if you have their fast hammer) that provide additional locking like a traditional pin set. This also allows you to not have to remove any of the springs that may be installed on the hammer like the j spring as is preferred if you use pins without the recesses. 2. The guiding angled screw pieces are extremely helpful in installing the pins while setting up a trigger as they slide the springs easily out of the way and guide the pins through the receiver pin holes (very helpful for tough j-springs even when using a guide pin and some extra safety against marring receiver pin holes). I know it seems like not a big deal but if you are a perfectionist and want to make sure your settings a