TinCuda from United States, TX Public Profile

I got the black version of this button. Most of these are made from plastic or aluminum. The one that I received was made from steel. It had a nice black finish, was cut mil-spec. This was just what I was looking for.

These are a good set of roll pin punches. They are inexpensive and work just fine. They are made from steel.

This is the best crush washer made. It tightens evenly and looks great. Once you try one, you will never use a different style again.

Good picatinny rail mount. It's made from steel and works just fine.

These are a good set of roll pin punches. They are inexpensive and work just fine.

Everything that you want in an upper receiver at a fraction of the price. Can't go wrong on these.

I don't like aluminum QD mounts. I don't trust them. This one is made from steel. Excellent quality and only a few dollars more. It is well worth the money.

Most H2 buffers have two tungsten weights and one steel weight that act like a dead blow hammer to reduce bolt bounce. This is one solid piece of steel. It looks well made and it is marked with a H2 stamp on it's face. The one I got weighed 4.37oz, most H2 buffers weigh closer to 4.6oz, so if you are looking for a buffer that is in between H and H2, this might be for you. I can't recommend it just because it does not have reciprocating internal weights.

Good parts from a solid brand. I bought these as spare parts for if I need to replace something quickly.

The trapdoor was completely unacceptable. It is made of plastic which didn't bother me as much as the trapdoor latch was a "V" type like you would find holding the battery compartment closed on a TV remote control. The trapdoor hinge was not a hinge, it was a plastic ribbon that bent when the door was opened. The rear stock endplate is also made of plastic and the buttstock to buffer tube screw is included, but is not drilled with a drain hole per mil-spec. The buffer weight is 5.16 oz and is made with dead blow weights. The spring was 32.5 cm or 12.8 inches or 12 13/16 inches long. The spring, buffer, and buffer tube seem to be of good quality and it is the only reason I gave this review two stars. The buffer tube was press fit so tight inside the stock that I had to use a mallet and punch to remove it from the stock. The stock is made from injected molded plastic and you can see the internal form lines on the outside of the stock. It is a nice black color with a matt black (not gray) textured surface. The surface scratches easily as mine arrive band new in a sealed plastic bag and it had marks and scratches from storage. The rough matt textured surface does look like a good choice if you plan to rattle-can paint your rifle. The A1 style of stock is a little shorter than the A2 style so the A1 doesn't need and buffer tube spacer and doesn't come with one. If you are looking for a beat-around stock or if you're arms are short, and you don't care about the super ch