Reviews & Ratings for Evolution Gun Works Picatinny Scope Mount, Henry — 11 reviews — Page 1

Best mount for your Henry rifles. Fit and finish is excellent.

Best mount out there for your Henry rifles. Fit and finish are excellent

Bought this for a Henry single shot 12 gauge shotgun. Fit perfectly. Highly recommend.

It says for Henry big boy. It will not fit the Henry X rifles.

Evolution Gun Works products are !st class quality. Good materials, fine fit and finish. Competively priced. This mount fits the Henry Big Boy perfectly. They use torx mounting screws and even provide the torx bit. This is a vast improvement over the Henry branded product which use standard slotted screws. EGW is my preferred supplier and enthusiastically recommend them.

Worked great on my steel side gate large loop .357 mag carbine. Easy to install and very secure.

Quality part well made easy to install works well with the Leopold rings that I purchased

Great quality product, highly recommend. I like how this party model sits lower and flush to the receiver instead of arched and taller like other models available on the market. Easy to install and even comes with the required drill bit in case you dont already have one.

Really nice fit from an American company. I have mine mounted to an Heirloom Henry Long Ranger and it fits perfect (Heirloom just means we got to pick our serial numbers). This rail should fit all Henry Long Ranger models.

The back of the mount (where the hammer sits above) is rounded and provided a great fit for where your thumb will be for a lot of your shooting.

The cutout along the top of the rail is nice, so you can leave your iron sights and have a “peep” view under your scope mount (depending on the scope you select).

Hex screws provided were high quality, machined well and they provide you the proper hex to use and the torque specs…and an extra hex (my kit had 5, which is a nice thing to have just in case for the future).

The overhang at the front (toward the muzzle), literally overhangs the flat cut out of the top of the rifle, so you end up getting 3/4 of an inch extra room to adjust your scope rings. The rail is a tad over 5” and, with a little blue Loctite (we use 243), should provide a lifetime of service.

Note: the holes on the rifle run THROUGH and into the bolt, so put the Loctite on the screws/threads first (on a napkin) let drip dry, then install…you can also wipe the interior where the bolt is housed just to be safe if you go overboard on the glue.

20lb is screw settings and you can go a little lower if you’re using Loctite.

Good luck!!!

Everything works well, all the parts was there and quality appeared great. Buy it. Mount appears strong and the color match the scope. They want a longer review but it is a simple piece of metal material