Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
Most Helpful Positive Review
Short thread protector
The barrel is slightly longer that the factory Beretta 92 barrel to allow enough space so the guide rod on the pistol does not hit a suppressor. Fit and finish are good and had no problems when tested. However, the thread protector is a little short and exposes the threads when tightened. You may ne...
Read More...
Read More...
Most Helpful Negative Review
Gemtech Threaded Barrel Factory Beretta 92 9mm .5-28 TPI 8889524
Purchased this barrel for my Beretta 92FS. After a little fiddling with the locking block, it dropped in fine & performed well with initial slide racking tests (empty chamber & no magazine). Took it to the range, loaded a full magazine, racked the slide and everything stopped. Couldn't fire a rou...
Read More...
Read More...
Gemtech threaded barrel for Beretta 92
Barrel was very good quality (expected as much from Gemtech).
No fitting was required and the barrel functioned perfectly
with and without a suppressor. Recommend using this barrel with
the Beretta 92A1 - the front sight can be replaced with a taller
one for use with a suppressor.
No fitting was required and the barrel functioned perfectly
with and without a suppressor. Recommend using this barrel with
the Beretta 92A1 - the front sight can be replaced with a taller
one for use with a suppressor.
Would recommend: Yes
1 of 1 found the following review helpful.