Don't know what the hype is. - HIPERFIRE Enhanced Duty Trigger AR Fire-Control Group w/Curved Trigger, 4.5/5.5lb Pull Weight

Replaced an ALG trigger with this because of the light high-speed hammer. The castings are rough especially where the hammer face contacts the firing pin. Not a smooth surface at all. Has some drag on the reset. After some polishing and stoning, the trigger is acceptable but for $100 bucks you shouldn't have to touch it up/ The ALG finish is much nicer and is Nickle boron coated but was willing to try the Hiperfire because of the hammer weight and lock up time. The nice thing about this trigger is there is very little over travel and no take-up with a small amount of pull thru when the sear releases. If your looking for a replacement "duty" trigger than I would go with the ALG or BCM. I could think of other things to waste my money on then a ho hum trigger I wont use.