Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
Expert Review
Easy Addition
I've add a couple of these to a few different guns, and they've worked great. Easy install, no issues with compatibility; pretty basic, but great piece. If you are running a Hub Mount set up, I would recommend this.
Most Helpful Positive Review
This is a well made mount
If you're into the HUB system as deep as a lot of us are then this is a great way to save some money with is just as good if not better mount.
Most Helpful Negative Review
Bad Threads
Bought & rec’d one, OD threads were out of tolerance & wouldn’t thread to dead stop, Bought and rec’d 2nd one and at 1st thought they had sent me the same one back again. That was impossible because of the shipping time, I re-ordered before I even returned as I was in need of it. I do not recommend ...
Read More...
Read More...
Worked like a champ
Got 2 1/2 28 5/8 24 both threaded On multiple guns and multiple Cans with No problems and worked like a champ. I always used a dab of high temp anti seize on the Cans I move to avoid carbon locking. I enjoy the short mounts on some builds.
Pros:
- cost
- Fit
- Weight
Cons:
- FDE unavailable
Best Used for:
- Cost saving
Would recommend: Yes
0 of 1 found the following review helpful.
Buyer beware 1 good 1 bad
I ordered the 1/2 x 28 and work as intended. I ordered one for my marlin 1895 11/16x24 and it will not screw all the way down. i sent it back and got another but it did the same thing. So it seem like the 1/2 x 28 will work but the 11/16x24 will not. Buyer beware
Pros:
- Cheap
Cons:
- Bad quailty control
Would recommend: No
0 of 1 found the following review helpful.
Knew better
I 100% knew better than to try this mount but was just trying to save a few bucks on a not so glamorous part that I was just planning to use occasionally on a 10/22. However, I should’ve listened to my gut as this thing is totally out of spec and doesn’t fully mount on my B&T. Just glad I didn’t keep trying and damage my can.
Would recommend: No
1 of 3 found the following review helpful.
Threads not fully machined.
Threads and the top of the mount are not cut/machined properly. As another person stated, they end prematurely and will not fit inside of silencerco can.
Pros:
- Price
Cons:
- does not fit
Would recommend: No
0 of 1 found the following review helpful.
Threaded Hub Mount
Fits as advertised, no problems ,nice product !!!!!!!!!!!!!!
Would recommend: Yes
1 of 1 found the following review helpful.
Bad threads on the hub side.
Threads end prematurely, if you can be patient and are ok with possibly sending it back for a replacement it’s a good deal.
Pros:
- Cheap
Cons:
- Quality control might screw you.
Best Used for:
- Getting your suppressor on a 22
Would recommend: Yes
1 of 2 found the following review helpful.
There are no reviews that match your criteria. Would you like to review this product?