KIDD Innovative Design Magazine Latch Plunger And Spring For Ruger 10/22
$19.99
$15.00
Save 25%
View Product
Compare (0)
1 item has been added
Add at least two items to compare
Most Helpful Positive Review
Kidd Innovative Design-Magazine Latch Plunger & Spring Ruger10/2
Attention Ruger 10/22 fans, I am upgrading my 10/22, part of my upgrade was replacing pins & springs that are prone to wear out. Originally was looking to replace just the spring but if any of you have ordered parts from Ruger you'll know what I mean here. Ruger has charged me more for shipping & ha...
Read More...
Read More...
Most Helpful Negative Review
I'm on the fence with this plunger
It's stainless, so that's nice. I'm ok with my purchase, but I won't be buying one for my other rifle. I also purchased the stiffer spring. I can't tell that it's any stiffer. It feels the same as the stock spring to me.
Smooth quiet action
Purchased a trigger bx trigger and the mag latch plunger felt super scratchy. Popped this one in and it’s all better. So smooth
Would recommend: Yes
great upgrade
Another easy upgrade to you’re 10/22, easy install, great results
Would recommend: Yes
terrible product even worse customer support
Out of spec would not retain and kidd was no help told me just return it where i got it.
Would recommend: No
no more misfeeds
I use a binary trigger and was getting a lot of misfeeds, but rarely get one now
Would recommend: Yes
Kidd Magazine Latch Plunger & Spring - Ruger 10/22
Attention 10/22 fans, this is not a part that goes bad under normal usage, however, as I am finding out personally Kidd Innovative Design products are well machined, as good as or better than factory original parts, & in this particular case, just look way cool installed. Not something the average Joe will notice when you have your gun out, but the serious 10/22 fan, hey that's just cool functionality!!!
Would recommend: Yes
0 of 1 found the following review helpful.
Does What It's Supposed To!
Easy install and fits perfect. It does tighten up the mag slop from the stock latch. BX mags fit nice and tight now but a couple of my Promag mags are a little tight going in with my Archangle stock kit but that might just be the new spring needed some break in time and that they are a promag for a 10/22.
Would recommend: Yes
1 of 1 found the following review helpful.
There are no reviews that match your criteria. Would you like to review this product?