Reviews & Ratings for Presma AR-15 Super Light M-LOK Series Free Float Handguards — 25 reviews — Page 1

The 13” handguard is perfect replacement for the short factory composite rail on my M4 22. Much more stable and feels good when shooting. Very impressed with the quality and the flexibility to add the picatany rails and a hand stop where needed. Will buy again for my next build.

Had a gunsmith install the barrel, barrel nut and rail on my AR build. The gunsmith was puzzled. He checked the bore and confirmed my Rosco purebred series barrel was true and straight, he lapped the BCM upper square and true, tried the barrel nut both ways as its threaded on both ends and still he couldn’t figure out why the barrel was closer to the right of the rail. I checked the barrel, bore sighted twice, confirmed everything was square and straight. Turns out the presma rail is bent. Still waiting for optics planet to send a replacement.

Fit was perfect. Couldn't be happier with it. Price is right also.

Mounted and works greats on my build and fast shipping thanks again

I do not know if it is my upper or the barrel, but nut would not index correctly with provided shims. It was either too much or too little. It seems a shim with half the width would do the trick, but alas, it is not included. This setup may work for some, it does not work for me, hence low rating and recommendation. In the future I will try and stay away from anything that requires shims to work - too much hassle and not enough flexibility.

This seemed like a great handguard as a decent price so I ordered it. It was the last component I needed to complete my build so I was excited to use this handguard. When it came in the mail I immediately took it out of the box to install on my AR and it sliced my trigger finger wide open. Not a small slice mind you, I mean serious, blood pouring, running along my hand and dripping on the floor if I took the pressure off it would continue to gush slice. I absolutely couldn't believe it! Never in my life have I dealt with something like this from just simply handling a part. The cuts for the picatinny rail were made so thin, at the edges they're like a razor if you apply any sort of slide or pressure. Now imagine you have a rifle you're holding, maneuvering at the range or wherever, and you slide your hand down the handguard to switch position or release the magazine, whatever, and your bleeding all over the place for no reason! This was so sharp I didn't even feel it until it was gushing. It was wild and I wasn't sure if I would need stitches. After about 30 minutes of very firm pressure and bloody paper towels the bleeding finally slowed to a trickle. I call the manufacturer to kindly let them know what happened and the guy on the phone didn't seem concerned at all. "What do you want me to do about it?" And I just told him, "I don't want anything, Optics Planet is handling this for me, but they told me to call you and inform you so y'all could check your product line." And h...
Read More...

I picked the most inexpensive hand guard so I could finish my build. This one is quite functional.

Very easy and quick installation process and very affordable product

The presma ar-15 and ar-10 supper light hand guardguard free floating.Are more product for less money.We have used several of thease handguards, they ship with barrel shims.in some .308 builds are a big plus. when headspacing is a problem,Only one down side tne the m-loc piece are made of plastic.I just switch them out for aluminum M- loc or-Key mod.

I have Bought several of these Prema Ar-15 and A-10 super light Handguards,And have not had any problems with any of them.The barrel nut fit is grate,And the the screws that hold handgard to the barrel nut fit on the Presma is a lined grate And tighting up.