Reviews & Ratings for SB Tactical SBT5 Pistol Stabilizing Brace for HK MP5/MP5K RS Clones — 28 reviews — Page 1

Some very minor filing for it to fit on my Mac 5. High quality product

I like it. Easy install, and it looks nice. It fits me perfectly. But if you are a tall person. it may be cramped. Verry afforable in comparison.

Installed on my full-size Military Arms Corp MAC-5. Expect to do some hand fitting as each brand of MP5 clones have some slight dimensional differences. Took maybe 10 to 15 minutes with a half round and a rat tail file to fit the brace to my receiver. I also had to elongate the pin hole in the brace ever so slightly. Fitting the brace was simple enough and once it is installed its rock solid. Totally changes the whole shooting experience. A brace is a must have on any MP5 clone and this SBT5 is a good choice.

This brace is going to marry to a MAC-5P, and both will enjoy a happy everlasting life

I purchased this brace for my future MAC MP5, and SB is always my first choice for braces.

Bought this for my ZF5. Build quality is fantastic and locks into open position solid and stays folded when you want. Fit super snug and has zero rattle or movement when firing. The only issue I had with it was that the bolt carrier group would go back when cycling, it would almost always stick at the back. First time, I took it all apart, found nothing looking off, and reassembled it. Everything seemed fine...until the next shot. Same thing. I happened to strike the rear of the brace on the bench and it went back into battery. I did this a couple more times and it was, sure enough, just sticking to the rear. Took it home and tore into it. It appears the "buffer pad" in the brace is considerably thinner and "squishier" (for lack of a better term) than the one from the ZF5 pistol end cap. I took the buffer pads off and swapped them (this required a slightly longer bolt...easily found at the local hardware store), but worked perfectly. Returned to the range a few days later it ran with zero failures (through about 500 rounds). Really love it now and plan to get one for my ZF56 when it gets here.

Sturdy amazing quality good fit fast shipping great customer service

Have SB on both my Zenith ZF5 models now. work great, look,great but both required some minor work with micro files.

I kept shooting low and left due to the recoil but after my brace. I was back on target again!

Took some light percussive persuasion to get it to seat the first time (on an MKE AP5 if it matters) and that's a good thing. No wobble, tight lockup, it's a solid piece of gear.