Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
Most Helpful Negative Review
Skip this one
Plastic endcap broke apart and roll pin was too short which allowed it to oval out the hole on the one side it was supported
Wasn't expecting a geissele..... But...
I think it was made overseas. It has bad tool chatter on the body where the buffer spring sits. It's not smooth. Whoever was running the machine needed to flip his lathe insert. Fits in a milspec tube and shares the same dimensions as a solgw bugger I have. Gave it 4 stars cause it's held up to half a case (450 rounds, 15 mags technically) of xtac 62gr with no issues. The end rubber/nylon/plastic is hard and I've had no issues with it walking out... Not bad for under 10$.
Pros:
- Hard end
Cons:
- Tool chatter
Best Used for:
- Budget
- Poverty builds
Would recommend: Yes
lacking chamfer
Had a heck of a time trying to get this over the detent. A chamfer under the large diameter is kind of necessary to get the buffer to go smoothly over the detent, this doesn't have it. I think they skipped a step in the machining.
Would recommend: No
There are no reviews that match your criteria. Would you like to review this product?