by
Dogcat1,
from TX, United States
Written on January 14, 2024
Well made, perfect. Never an issue! No lapping needed. Perfect!
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
Mike,
from GA, United States
Written on October 27, 2020
They were mounted on a L61 Sako action chambered in 358 Norma Mag so there is a good deal of recoil. I love the feel and the mounting system of the top and bottom screws. So far (40-50 rds) have had no issue. Happy
Would recommend: Yes
1 of 1 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
Tubbs,
from VA, United States
Written on February 23, 2020
Very positive clamping ring.(full contact w/dove tail base). Comes in three different heights. .100 thousands increments. Due too my new scope having a big diameter eye piece my bolt handle would not clear the scope. Had to go up a size in ring height. .100 thousand increments works out great, enough height for clearance issues without having your scope way too high off receiver.
Pros:
- Slim,not bulky/ Very strong.
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
Eighteen Whlsrolin,
from TN, United States
Written on August 7, 2018
They are not cheap but they are solid and fit and finish is excellent. These are two piece rings so read instructions for proper order on tightening/torqueing so that they will be firmly attached to base and have good even pressure on scope. I have two sets of these and mounted them to Talley mounts/bases so not sure if they would work with any other mount/base type. Holds zero perfectly on lightweight 45-70 and 30-40 krag single shot rifles. Scopes are weaver 1-3x20 for 45-70 and Leupold 2-7x33 for 30-40 krag. Talley and DNZ are my go to companies for scope mounting.
Pros:
- Holds scope solidly, nice finish, last forever
Cons:
- A little pricey but very much worth it if you plan to keep the firearm
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
Big Riv,
from AR, United States
Written on May 27, 2018
I use Talley Fixed Rings and Bases on my Magnum Rifles. They look great, easy to install and they " Do Not Move" I would put them on my Rifles, but they are pretty exspencive. I use their lightweight mounts also. They are made of Aluminum and about half the price.
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
Mgreen,
from AZ, United States
Written on February 13, 2018
These Talley rings are the perfect fit. I replaced the “Bridge Loc mount” on my TC Dimension because of failure. The scope (50mm objective lense) clearance is perfect.. These rings along with the Talley bases recommended for this rifle are well made and fit perfectly. I would highly recommend a Talley setup.
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
Husker,
Verified Owner
from NE, United States
Written on February 27, 2017
These rings are excellent. Great quality and value. I have used other rings in the past and wouldn't even consider it now. They provide great strength while not a lot of weight. I'm using these rings on a 375 H and H Cooper rifle.
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
BL,
Verified Owner
from TX, United States
Written on August 23, 2016
Ordered the medium height rings with Talley bases for my Sako 85 Finnlight in 7mm Rem Mag to mount a 4-16x50 scope. Getting the scope situated wasn't as easy as the Sako Optilocks but it works great and clearance is right. The people at Talley were very responsive and helpful to questions on correct height rings/bases.
Would recommend: Yes
1 of 1 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
Jeffy,
from MT, United States
Written on August 2, 2016
The best you can buy solid construction durable no need to worry about your rings moving well worth the money you pay! Not much else to say but they make me keep writing to get the discount that comes with the review
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?
by
Turkeyrooster,
from SC, United States
Written on June 11, 2016
Talley rings and bases are superior products with the availability of picking up the phone and calling for exact fit. Customer service is on standby to answer any question. The rings fit perfect as described of metal and larger screws to stay positioned.
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you?
Yes
|
No
You said this review was not helpful.
Would you like to change your vote?