Reviews & Ratings for TRYBE Defense Glock 20 Match Grade Non-Threaded Pistol Barrel — 12 reviews — Page 1

This is for 10mm barrel only review. This barrel will not feed practice or flat nose bullets. It noses all brands up and jams every round
So you can't find a practice round you have to use pointed or defensive rounds which would be expensive.

Dropped in and failed to feed with every mag and round type I put into it. Polished the heck out of the feed ramp. Still failing. Inspected the chamber. Small defect at the top, just enough to create enough friction for the round not to load. Attempted to polish that. No dice.

I bought it two weeks before Memorial Day Weekend and paid much for than the M.D.W. price. At first, my slide hung up on the Trybe barrel vs the stock Glock barrel. I marked the contact areas on the lower with a black marker, racked the slide several times and noted where there was contact. I took a fine carborundum stone and polished the contacts on the lower, rounded off all sharp edges on all lower contact areas. Tested again and was better, repeated the process until the slide was silky smooth and went into battery. Fired a bunch of rounds without a single hic-up. To be fair, the slide on the Glock was also hanging up a bit on the stock Glock barrel, but was worse on the TRYBE. I bought the Trybe so I could fire hard cast 10mm lead. Life is good.

Great barrel for my 10mm build. I have both treaded and non treaded 10mm barrels.

100% jam when feeding. Chamber end of feed ramp seems too narrow, to the point that cartridge cases have two parallel scratches

Performed quite well in my Glock 20 SF, Armorally slide, and LAX 10 MM ammo.

Haven't yet used it but the fit is perfect and the finish looks great. Will update after I head to the range for a trial run.

So barrel I bought was gold but when I recieved it the thing had lots of scratches and discoloration on bottom. Being it's hid by the slide I decided against sending back and waiting the two weeks to get a new one as bear seasons right around corner and need it on my side.so can't say it's the product or shipping or careless housing but a new item should be perfect. Customers work hard to be able to buy these things.

tested this past weekend. Accurate and reliable with both std and +P loads in 10mm
Happy with this purchase to convert a G21 to G20.

Looking forward to putting some more time behind this barrel.

Really wish this barrel had the cartridge stamped somewhere on it.

I'm building one-off custom guns based on the Glock 30 and 29. One (30) is 45 ACP and the other (29) is 10mm. To do this, I'm combining a G30 slide (I have a Gen 3 and a Gen 4 slide) onto a custom G21 shortened frame. The G30 went together well with a LWD G21 barrel cut to length and custom length recoil spring, and it runs beautifully.

The 29 was a different story. The slide will not go onto the frame unless the slide lock is pulled down- this is a barrel issue. I can't get it to chamber a round out of the mag- the setup uses 10mm specific parts in the slide and also an OEM G20 mag. I pulled the barrels and looked at them closely. A picture would be worth 1K words, but I don't see a way to attach one. The enlarged portion for the chamber is slightly shorter on the Trybe barrel. The forward lug is also offset slightly forward. Since I've cut this to length, I can't return it. When I was able to chamber a round, the bullet did come out of the barrel when I pulled the trigger, so that part was OK. :)

These barrels should work in a G21 setup, but for some reason this one doesn't. It may have worked OK in a G20. Since that was not my application I can't properly rate it, so I'm giving it a neutral 3/5 stars.