Jimy from United States, MA Public Profile

This is a great stock, very lightweight, sturdy. However, many of the reviews ding this for not having a spring, not being easily adjustable, using a roll pin, etc. THAT IS THE POINT OF THIS PARTICULAR MODEL. The “compliant” model is for people who live in restricted states where telescoping stocks are deemed illegal. If you live in a normal state, they also make a version that is fully adjustable. You should probably order that one.

This stock can be adjusted for length of pull by knocking out the roll pin with a punch, setting your length of pull, and then reinstalling the roll pin.

As a side note, I found that a rifle I installed this on had its original stock drilled and permanently affixed to its buffer tube. There was no easy way to remove it, so I ordered a new buffer tube to accompany this stock.

If you live in a restricted state, order without hesitation!

I ordered this to help me change my buffer tube and stock on a “compliant” rifle. I wanted to replace the factory pinned stock on my rifle with a MFT Minimalist stock. So I ordered this wrench (“buy once, cry once” as some other reviews stated). It’s my own fault for not realizing this earlier but unlike many other castle nut wrenches for sale, this one requires you to slide the wrench completely over the buffer tube from the end. Well, if you have a pinned stock, it is impossible to remove the stock without a drill to slide the wrench on. So this wrench is sort of useless for my particular project. An open design like almost all other castle nut wrenches would solve this issue. Again, I should have realized this before ordering. I wanted to give a heads up to you before making the same mistake I did. That being said, this is a solidly made tool that will last longer than I do. But I’ll be ordering another (much cheaper) wrench to “supplement” this one. I’ll probably keep both!